When I test the 0.75beta. I discover I could not read any code of the page by pressing the "view source".
This message is show on the screen :
"Protocol Not Known Error
Connection Failure Error
Net Timeout Error
Redirect Loop Error
Unknown Socket Error
Net Reset Error
Offline Error
view-source is not a registered protocol.
The address (URL) is not a valid format and cannot be read. A typical address will start with "
http://", followed by an address, (e.g.
http://www.netscape.com), followed by a path to the content (or just "/"). A common cause for the problem is using backslashes(\) instead of forward slashes (/).
The file specified by the address (URL) cannot be found. Check that the file exists and that you have sufficient permissions to view it.
The address (URL) does not correspond to a known site and could not be loaded. This could be due to a misspelling in the address or because the site does not exist. If the address is known to be valid, or if the problem occurs for many sites, it may be an issue with your proxy service (if you use one) or the directory name service lookup. In such cases you should consult your system documentation, administrator or Internet Service Provider (ISP) as appropriate for further assistance.
The address (URL) starts with a protocol that is not recognized by the browser. A protocol is the part at the front of the address, such as http: or ftp: which tells the browser how to connect to the site. In this instance, the protocol is unknown so loading cannot continue. Check that the address is correct before retrying."
Thanks for your advise,
rainman